WIRELESS REMOTE-CONTROLLED STUMP GRINDERS - THE FUTURE OF THE INDUSTRY

In 1898 Nick Tesla demonstrated a radio-controlled boat, which he dubbed "teleautomation".

Nearly a century later, JP Carlton, located in Spartanburg, South Carolina, pioneered the first wired (tethered) remote-controlled stump grinder.

It was only a few years later that this groundbreaking technology was developed into the first wireless remote-controlled stump grinder.

With over twenty-five years of experience developing wireless remote stump grinders, JP Carlton is the industry leader in this technology.

Would you consider purchasing a TV without a remote control?

DIGITAL TRANSMISSION INTERFERENCE-FREE

Our rugged, portable, long-range, programmable radio remote transmitter and receiver incorporates vibration, temperature, and humidity-tolerant electronics that operate at 2.4 gigahertz.

The T151 transmitter (radio remote) uses four AA batteries and has a range of approximately 100 m.

Each T151 transmitter uses a unique ID code to ensure that no two systems will conflict at a job site.

This trusted wireless uses Frequency Hopping Spread Spectrum (FHSS) technology that has proven to be extremely reliable under heavy interference and in noisy high-voltage environments.

This FHSS device concentrates its full power into a very narrow signal that randomly hops from frequency to frequency within a designated band.

This transmission pattern, along with the CRC-16 error-checking techniques, enables signals to overcome interference that commonly affects licensed radios.

Features of this wireless system include:

• 100M Range at 2.4 Ghz
• Plug & Play Installation
• Resilient To Impact And Shock
• E-Stop (Emergency Stop Will Turn Off Engine)
• FCC, ISC, CE Approved
• Rated To 160 Hours Of Continuous Use

HOW TO SYNC THE WIRELESS REMOTE VIDEO

This video demonstrates how to sync an OMNEX remote with either a Red Roo or JP Carlton wireless remote control stump grinder.

HOW TO SYNC THE WIRELESS REMOTE INSTRUCTIONS

The procedure below explains how to sync an OMNEX remote with either a Red Roo or JP Carlton wireless remote control stump grinder.

Step 1. Turning The Radio On
Step 2. Press the E-Stop (emergency stop button) all the way in
Step 3. Toggle any switch on the remote
Step 4. Twist and release the E-Stop

STAY OUT OF THE DIRT, DUST AND DEBRIS